www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
33
13. Electrical connection
The electrical motor installed is connected and
ready for operation. The connection complies
with the applicable VDE and DIN provisions. The
customer‘s mains connection as well as the ex-
tension cable used must also comply with these
regulations.
Important information
In the event of an overloading the motor will switch
motor can be switched back on again.
Damaged electrical connection cable
The insulation on electrical connection cables is of
ten damaged.
This may have the following causes:
• Passage points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been im
properly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the
wall outlet.
•
Such damaged electrical connection cables must not
damage.
regularly. Make sure that the connection cable does
not hang on the power network during the inspection.
Electrical connection cables must comply with the
applicable VDE and DIN provisions. Only use con
The printing of the type designation on the connec
tion cable is mandatory.
AC motor
•
• Extension cables up to 25 m length must have a
cross section of 1.5 mm
2
.
only be carried out by an electrician.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
•
• Do not use any aggressive cleaners, or sharp or
metallic cleaning utensils such as knives, hard
scrapers or similar. They could damage the sur
faces.
1.
2. Keep the protective devices as free of dust and
dirt as possible.
3.
tective goggles when using compressed air.
4. Use a damp cloth and a small amount of soft soap
if it is heavily soiled.
Note: Proper, regular care is not only important for
safe use, but also helps to extend the service life of
the plunge saw.
Replacing the connector cord
If the mains connection line of the plunge saw is dam
aged, it must be replaced by the manufacturer, its
order to prevent risks.
Checking the plunge saw
Regularly check the condition of the plunge saw.
Among other things, check to make sure:
• that the switches are not damaged,
• that the accessories are in proper condition,
• that the mains connection line and the mains plug
are not damaged,
• that the vents are unobstructed and clean. If appli
cable, use a soft brush to clean them.
If you identify any damage, you must have the
plunge saw repaired by a specialist workshop to
prevent risks.
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol
lowing parts are therefore also required for use as
consumables.
* Not necessarily included in the scope of delivery!
12. Storage
Store the device and its accessories in a dark, dry
and frostproof place that is inaccessible to children.
The optimum storage temperature is between 5 and
Store the electrical tool in its original packaging.
and moisture.
Store the operating manual with the electrical
tool.
To Next Page
Loading...
