Scheppach PLM1800 User Manual

www.scheppach.com
24
|
GB
Explanation of the symbols on the equipment
Symbols are used in this manual to draw your attention to potential hazards. The safety symbols and the accompa-
nying explanations must be fully understood. The warnings themselves will not rectify a hazard and cannot replace
proper accident prevention measures.
Read and observe the instructions manual and safety regulations before starting the ma-
chine!
Wear ear-mu󰀨s!
Wear a breathing mask. Dust which is injurious to health can be generated when working on
wood and other materials. Never use the tool to work on any materials containing asbestos!
Wear safety goggles. Sparks generated during working or splinters, chips and dust emitted
by the device can cause loss of sight.
WARNING! Risk of injury! Never reach into the planing knife during operation.
Wear protective gloves when changing the blade!
Overload switch
Feed direction
m Attention!
We have marked points in these operating instructions that impact your safety with this
symbol

Scheppach PLM1800 Specifications

General

Type	Paring chisel
Power	1500 W
Material	Plastic, Steel
Feed rate	7.4 m/min
Idle speed	8500 RPM
Handle color	Black, Blue
Handle material	Metal, Plastic
AC input voltage	230 V
Number of blades	2
AC input frequency	50 Hz
Surface planing material removal (max)	152 mm
Thickness planing material removal (max)	330 mm

Weight and Dimensions

Depth	630 mm
Width	589 mm
Height	500 mm
Thicknessing table dimensions (W x D)	330 x 630 mm