www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
21
•
workpiece into contact with the grinding wheel. Af-
•
times when working.
•
•
grinding wheel(s) to come to a standstill.
• -
plug out of the mains socket.
• -
of oil or grease.
•
are doing and proceed with caution. Do not use
feeling unwell.
•
not subject to mechanical loads or damaging en-
• Do not use damaged or unshaped wheels.
• The adjustment of the spark guard shall be made
wheel, keeping the distance between the guard
and the wheel as small as possible, and no greater
than 2 mm.
• The adjustment of the work rest shall be made
wheel, keeping the distance between the work rest
and the wheel as small as possible, and no greater
than 2 mm.
•
arbor of the grinder. Do not attempt to machine an
• Do not overtighten wheel nut.
• Do not grind on a cold wheel. The grinding wheel
should be started and run at idle speed for one
• Do not grind on the side of the wheel. Grind on the
•
Coolant can weaken the bonding strentgh of the
wheel and cause it to fail.
• Sparks are a hazard. Do not grind near gas or
• Stand to one side of the wheel when turning on the
the side of the wheel can cause it to become too
thin for safe use.
• Grinding creates heat. Do not touch the work piece
• Use grinding wheels that are rated for safe use on
the grinder. Do not use a wheel that is rated lower
than the grinder speed.
Safety advice relating specically to bench
grinders
• Do not touch the mains lead if it becomes dam-
-
• Do not operate the device if it is damp and do not
use it in a damp environment.
•
it through a residual current device (RCD) with a
maximum trip current of 30 mA. If using an ex-
outdoor use.
• If a dangerous situation arises, pull the mains plug
•
from the rear of the device.
•
-
ing area.
• Warning! Noxious fumes! Working with harmful /
noxious dusts represents a risk to the health of the
the work area.
• Wear protective glasses, hearing protection, dust
protection mask and protective gloves.
• Danger of burns! The workpiece gets hot during
grinding for longer periods, stop grinding from time
to time and allow the workpiece to cool before con-
tinuing. Do not operate the device for continuous
periods exceeding 10 minutes.
•
grinding of the surfaces of metal objects. The de-
• Do not grind materials containing asbestos. As-
bestos is a known carcinogen.
• Do not use damaged grinding wheels.
• -
spond with those given on the device ratin plate. The
circumferential speed should be equal to or greater
than the value given on the device rating plate.
•
grinding wheels can be evened out. Keep the gap
as small as possible.
• Avoid contact with the moving grinding wheel.
• Never leave the device working unattended.
• Never use the device for a purpose for which it
was not intended.
•
To Next Page
Loading...
Need help?
General
