www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
22
|
GB
Vibration emission value a
h
2
2
Warning!
-
change according to how the electric equipment is
-
tional circumstances.
-
pare the equipment with other electric powertools.
Keep the noise emissions and vibrations to a
minimum.
• -
order.
•
•
• Do not overload the appliance.
•
•
• Wear protective gloves.
7. Assembly
-
identical to the mains data.
-
ments to the equipment.
• -
or similar.
•
•
• Check that the voltage on the rating plate is the
Warning! Never connect the plug to power source
outlet until all installations and adjustments are com-
and operation instructions.
Tool support (left and right) (Fig. 1, 2, 2.1)
Fasten the tool support (4) to the grinding wheel
guard (6) with the mushroom head screw (M6x10) (a)
and the star grip nut (b).
The distance between wheel and work rest should
not exceed 2 mm.
•
wheels or brushes.
•
a rotational speed which is at least as high as the
speed indicated on the rating plate of the electrical
tool.
•
order to limit the risk of contact with the rotating
spindle.
6. Technical Data
Delivery
Bench Grinder
SM150LB
User’s Manual
Technical Data
Dimensions L x W x H 380 x 210 x 280 mm
Grinding disc max. ø 150 mm
Grinding disc min. (after
wear and tear)
ø 110 mm
Brush max. ø 150 mm
Brush min. (after wear) ø 120 mm
Grinding disc bore max ø 12,7 mm
Brush bore max. 20 mm
Brush width 13,5
Lamp
Weight 7 kg
Motor
Motor 230-240/50 V/Hz
Input power S2 10 min 400 W
Motor speed 2850 1/min
Subject to technical changes!
Load factor:
at its nominal power level (400 W) for no longer than
limit the motor will overheat. During the OFF period
the motor will cool again to its starting temperature.
Sound and vibration
Sound and vibration values were measured in ac-
cordance with EN 62841.
L
pA
sound pressure level 64,9 dB(A)
K
pA
3 dB
L
WA
sound power level 76,1 dB(A)
K
WA
3 dB
Wear ear-mus.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 62841.
To Next Page
Loading...
Need help?
General
