To Next PageTo Next Page
Why is there a delay before unlock after entering a valid User Code on my Schlage door lock?
If you're experiencing a delay before the Schlage door lock unlocks after entering a valid User Code, the battery is likely low and should be replaced.
Why does my Schlage door lock keypad not light up when I press the numbers?
If the Schlage door lock keypad does not light up when the numbers are pressed, it may be because too many incorrect user codes have been entered. Wait 30 seconds and try again. If the keypad still doesn't respond after 30 seconds, replace the battery.
Why does my Schlage Locks keypad not light up when numbers are pressed?
If your Schlage lock's keypad doesn't light up when you press the numbers, it could be due to a couple of reasons. First, too many incorrect User Codes might have been entered. In this case, wait 30 seconds and try again. If the keypad still doesn't respond after 30 seconds, the battery might need replacing.
How to find the default programming code for Schlage BE365?
To find your Programming Code, check the front of the Keypad Locks Programming Guide or the back of the keypad assembly for the default Programming Code. If needed, you can restore the lock to factory settings.
What to do if Schlage door lock does not light up when numbers are pressed?
If your Schlage door lock doesn't light up when you press the numbers, it could be due to a couple of reasons. First, too many incorrect User Codes might have been entered. Wait 30 seconds and try again. If the keypad still doesn't respond after 30 seconds, you may need to replace the battery.
What to do if my Schlage Locks is in Vacation Mode?
The reason the lock is not working as expected is that Vacation Mode is enabled. Disable Vacation Mode to restore normal operation.
Why can't I delete all User Codes on my Schlage Locks?
If you cannot delete all User Codes from your Schlage lock, it is possible that the Programming Code was entered incorrectly the second time.
Why is my Schlage Locks blinking red but no codes have been entered?
If your Schlage lock is blinking red and no codes have been entered, the battery is dead and must be replaced.
Why is my Schlage door lock blinking red?
If your Schlage door lock is blinking red and no codes have been entered, the battery is dead and must be replaced.
What to do if I forgot my Schlage Locks programming code?
General| Lock Type | Deadbolt |
|---|---|
| Keypad | Yes |
| Material | Metal |
| Keyless Entry | Yes |
| Number of User Codes | 19 |
| ANSI/BHMA Grade | Grade 2 |
| Weather Resistance | Yes |
| Power Source | 9V Battery |
| Finish Options | Aged Bronze, Satin Nickel |
| Backset | Adjustable 2-3/8 to 2-3/4 inches |
| Operation | Keypad |
| Warranty | Limited Lifetime |
