Schlage CONNECT - Factory Reset Procedure; Restoring Default Settings

Factory default reset
1. Disconnect
your batteries.
2. Press and hold
down the
logo.
While you are pushing
the logo, reconnect
your batteries.
3. Test your lock
with one of your
default codes,
located on the
back of this
guide.
If you have forgotten your programming code, you can restore the
default codes. If you want to move the lock to a different door, you
need to restore default settings. Move the lock to the new door,
and then set it up again.
Now set
up your
lock, see:
10
step