Watson-SHDSL-Router-Manual.doc
Version 1.0-03
Watson SHDSL Router
Operating Manual
Installation Precautions
For safety reasons observe the following installation configurations:
• Shelf or desktop
Watson SHDSL router can be installed on a shelf or desktop, as a standalone unit. The
unit should only be put into position on its rubber feet. If the installation includes more than
one unit, they should not be stacked on top of one another to prevent overheating.
• Wall mount
Wall mounting using the original wall mounting kit (not included in the package) should
only be done the following way: Orient the unit so that the top is facing you, the front panel
is at the top and the back panel with the connectors is at the bottom. Cables should only
be connected to the unit when the wall mounting installation is completed.
This product is designed for operation in the electromagnetic environment typically found in com-
mercial, domestic and telecommunication installations:
The electromagnetic compatibility (EMC) requirements for this product have been selected to
ensure an adequate level of immunity to electromagnetic interference in the typical operating
environment. The levels do not, however cover extreme cases which may occur in any location
but with a low probability of occurrence. In special cases, situations may arise where the levels
of interference may exceed the immunity levels. In these situations, special mitigation meas-
ures may have to be employed.
Revision: 2007-05-24 vii
To Next Page
Loading...
