62 63
english
3. Move the face shield upwards until
it is released from the face shield
mechanism.
Fitting the face shield
1. Using both hands, guide the face
shields locking studs into the
respective recesses in the face
shield mechanism.
2. The face shield will then audibly
lock into place when you press it
gently towards the helmet with a
simultaneous closing movement.
3. Make sure that the face shield
mechanism is functioning properly
by opening the face shield once to
its maximum extent.
When you push the face shield open, it may well travel beyond
the urban position, but it is easy to find this position by moving
it downwards again. The face shield mechanism requires no
additional lubrication. The face shield can be operated at any time
irrespective of the position of the sun visor.
Closing the face shield
To close the face shield, grip the
finger tabs at top left and right and
press the face shield down with one
movement until it audibly locks into
place.
REPLACING THE VISOR SHIELD
Changing the visor shield is easy to do without tools using the
convenient EasyChange visor mechanism. To replace the visor,
it is helpful to place the helmet on a flat surface or on your lap
while seated.
Removing the face shield
1. Move the face shield into the
uppermost locked position.
2. Press the spring underneath the
face shield mechanism on one side
towards the face shield opening,
then do the same with the spring
on the other side.
C. THE HELMET
english
To Next Page
Loading...
Need help?
General
