64 65
english
PINLOCK
®
VISOR
Fitting
1. Lay the Pinlock
®
visor in the face
shield in such a way that one side
of it is already slotted into the
locking pin and the silicone seal is
on the side facing the face shield.
2. Now grasp the other side of the
Pinlock
®
visor by its upper and
lower transverse edges and use
your index finger to gently press
the end of the visor into a slight
"S" shape. Now you can easily
guide the slot over the locking pin
and release the Pinlock
®
visor into
place.
3. The Pinlock
®
visor should now be
positioned in the face shield with
its lower edge parallel to the lower
edge of the face shield. If you
need to change the positioning of
the Pinlock
®
visor, use the balls of
your thumbs to gently bend the
face shield apart until the inner
visor can be adjusted as required.
4. Check all round the visor to make
sure that the silicone seal fits
tightly and evenly against the
face shield. Only if this is the case
will the anti-misting properties
function properly.
5. If you have not done so already,
remove the protective film from
the Pinlock
®
visor
If the Pinlock
®
visor is not air-tight and the face shield mists
up, either the visor is not correctly in place or the pressure on
the seal is inadequate. You can regulate the pressure on the
seal by adjusting the eccentric locking pins. To do so, remove
the Pinlock
®
visor, then use a flat object with no sharp-edges
to push the locking pins out of the face shield carefully from
the inside; then rotate them by 180° and reinsert them. Fit the
Pinlock
®
visor and check the seal.
Removal
1. Before starting to remove the
Pinlock
®
visor, first lay the face
shield on a soft, clean cloth so
that its top edge is facing you.
2. To reduce the pretensioning of the
Pinlock
®
visor slightly if necessary,
use the balls of your thumbs to
carefully bend the face shield
sufficiently apart while applying
pressure with your thumbs to
release the Pinlock
®
visor and
move it approx. 2-3 mm forward.
C. THE HELMET
english
To Next Page
Loading...
Need help?
General
