88 89
english
3. INNER LINING
The inner lining of the S2 can be removed completely. The head
and cheek pads can be washed by hand using a mild soap
solution (e.g. with highly diluted standard mild detergent) at a
maximum temperature of 30 °C. Allow the lining to dry at room
temperature and with good ventilation. (For removal of the inner
lining, see Section C.12.)
Tip:
If required (e.g. during a break in a journey), the headband
can be hung out to dry over the mirror.
4. VENTILATION
Ventilation cowl
When necessary, the head ventilation system’s air inlet cowl can
be removed to clean the ventilation mechanism.
1. To do this, first remove the control
unit by simply lifting it out of the
ventilation cowl.
2. Then slide the flat end of the
control unit under the edge behind
the ventilation cowl and remove
the latter by levering it upwards.
G. MAINTENANCE AND CARE
3. On completion of the cleaning,
fix the ventilation cowl back in
place by hooking it into the front
of the ventilation mechanism and
pressing it into the helmet shell
until you hear an audible click.
4. When this has been done, insert
the control unit through the
ventilation cowl and into the
ventilation mechanism.
5. LOCKING SYSTEM
Ratchet fastener
The metal components of the locking system do not require
maintenance.
6. STORING THE HELMET
Store the helmet in the helmet bag supplied in a dry, well-
ventilated and stable place. Always position the helmet so that
it cannot fall to the floor. Damage that occurs in this way is not
covered by the warranty.
Note:
Store the helmet out of the reach of children and animals.
english
To Next Page
Loading...
Need help?
General
