5.2-32
005.050.01-EN
14.2 WORK INTERRUPTIONS
Danger in case of unauthorized
use!
Never lay the radio control
transmitter aside while it is
ready for operation. The trans-
mitter must always be off and
locked away.
– To stop individual functions, set the corre-
sponding selector switch on the transmitter
to position "0".
– For shutting off the transmitter press the emer-
gency stop button 3 (Fig. 1)
The transmitter sends the emergency stop sig-
nal which stops the most important machine
functions immediately.
After sending this signal, the transmitter shuts
off automatically.
For restarting, the transmitter must be re-
initiated as described in chapter 12.
If the transmitter is shut off while
selector switch 3 (Fig. 2) is in the
"Remote control" position, the VEC-
TOR control system switches over
automatically to the protected EMER-
GENCY STOP state.
- If this is not desired, selector switch
3 must be set beforehand to the
"Local control" position.
Fig. 1
Fig. 2
To Next Page
Loading...