5.2-35
005.050.01-EN
14.6 END OF OPERATION
If the transmitter is shut off while
selector switch 3 (Fig. 1) is in the
"Remote control" position, the VEC-
TOR control system switches over
automatically to the protected EMER-
GENCY STOP state.
- If this is not desired, selector switch
3 must be set beforehand to the
"Local control" position.
– Shut off the transmitter with the EMER-
GENCY STOP button 3 (Fig. 2).
– Lock up the transmitter in the driver's cab, if
it is no longer needed.
- Keep the transmitter in a safe
place to avoid uncontrolled ac-
tivation during transport.
- Always make sure your trans-
mitter is with you before set-
ting off. There are cases where
transmitters have been left be-
hind on construction sites.
– Shut off the machine control with the switch
in the driver's cab.
– Deactivate the P.T.O. of the truck
Fig. 1
Fig. 2
To Next Page
Loading...