Schwing SC30 - Putting the Radio Remote Control into Operation

5.2-27
005.050.01-EN
12. PUTTING THE RADIO REMOTE CON-
TROL INTO OPERATION
12.1 SWITCHING ON THE RECEIVER
– Make sure cable connector 8 (Fig. 1) of the
radio control receiver is plugged into the cor-
responding socket at the machine control
cabinet.
– Switch on the machine control and set up
the machine as described in the truck-moun-
ted concrete pump operating instructions.
– Set selector switch 3 to "Remote
control“.
The receiver display (Fig. 2) shows the fol-
lowing status code: standby mode: trying to
find transmitter
The contact with the transmitter is not yet
established.
The VECTOR control remains in the emer-
gency stop state.
Fig. 1
Fig. 2