TheLevelduringCoolDownisbasedontheLevelattheendoftheworkout:
End Level Cool Down Level
Level _<3 1
3 < Level _<10 3
10 < Level 5
You can push STOP to stop the Results display and go back to Power-Up Mode. If there is no
RPM or HR signal, the Console automatically goes into Sleep Mode.
Pausing or Stopping
The Console will go into Pause Mode if the user pushes STOP during a workout, or there is no
RPM signal for 5 seconds (user not pedaling). The Console display shows WORKOUT PAUSED,
and after 4 seconds the current workout data starts to scroll automatically (the same format as
Results Mode). You can use the Increase/Decrease buttons to move through the results manually.
1. Push the STOP button to pause your workout.
2. To continue your workout, push START/ENTER or start pedaling.
To stop the workout, push the STOP button. The Console will go into Results / Cool Down
mode.
To Next Page
Loading...
