Schwinn 26” - Assemble the Front Brake

15
Attach the Front Fender
Parts: Front fender, main frame
Hardware: washer, long screw, small screw,
contoured washer
Tools: Phillips head screwdriver, adjustable pliers
See the facing page for diagrams of the following steps.
1. Remove the fork protector (not shown).
2. Disconnect the brake noodle from the brake
carrier by:
a. Using a 5 mm allen wrench loosen the
cable anchor bolt enough so the cable
can move freely.
b. Lift the brake noodle and cable out of the
brake carrier.
3. Remove the hardware from the fork.
4. Position the front fender so the attachment bar is
on the outside of the main frame.
5. Place a washer on the screw and slide it through
the attachment bar, and the hole in the fork.
6. Place the spacer on the end of the screw, making
surethecontourofthespacertsthecontourof
the fork.
7. Place the washer and nut behind the spacer, and
loosely tighten.
8. Align the fender braces with the small hole in the
fork and loosely screw the fender braces to the fork.