Schwinn 26” - Attach the Rear Fenders

28
Attach the Rear Fenders
Parts: Rear Fenders, rear frame
Tools: Phillips Head screwdriver (minimum 4” shaft)
Hardware: 4 nuts, 4 screws, 8 washers The hardware
comes attached to the frame. Remove the
hardware before you begin this procedure.
1. Positionthefendersotherearreectorisfacing
away from the bike.
2. Rotate the rear wheel until there is adequate space
for the Phillips Head screwdriver to reach through
the spokes to the fender slots.
3. Align the slots on the fender with the slots on the
rear frame.
4. Insert a washer onto a screw.
5. Insert the washer and screw through the aligned slots.
6. Insert a washer and nut on the end of the screw.
7. Hold the nut with the pliers, and tighten the screw,
but not completely.
Note: Be sure that the fender has adequate clearance
from the wheels. It may be necessary to adjust the
fender slightly to properly align with the wheels.
1
2
3
8. Repeat steps one through six for the second slot.
9. Firmly tighten both screws.
10. Repeat steps one through nine for the second fender.
4
5
6