Page 26
637-8808 Rev. J
Flywheel Position Adjustment
Required Tools:
• 3mm Allen Key
• 4mm Allen Key
• 19mm Open-Ended Wrench
In cases where the flywheel is not centered between the brake magnets resulting in rubbing or noise, it will
be necessary to adjust the flywheel position.
1. Use a 4mm allen key to remove he two (2)
socket head cap screws securing the left side
belt guard cap.
Fig. 50
2. Use a 4mm allen key to remove the four (4)
socket head cap screws securing the left side
belt guard to the bike, then remove the belt
guard.
Fig. 51
To Next Page
Loading...
