Scott Safety Epic 3 - Apx Radio Bluetooth Pairing Removal Process - One Display Radios; Termination of Use; Cleaning and Inspection; Cleaning

Page 18 of 21
P/N 595359-01 Rev A - 04/17
DRAFT COPY –
NOT FOR PUBLICATION
2. Alternatively, the Bluetooth pairing information can also be removed by
pressing the BT On/Off button (1-dot side button) for two seconds. The
APX radio will emit an audio tone indicating the pairing information was
removed.
APX RADIO BLUETOOTH PAIRING REMOVAL PROCESS - ONE
DISPLAY RADIOS
1. Press the BT On/Off button (1-dot side button) for two seconds. The
APX radio will emit an audio tone indicating the pairing information was
removed.
TERMINATION OF USE
Exit from the area requiring respiratory protection. After leaving the contaminated
area and arriving in a safe, clean atmosphere, decontaminate as required by your
respiratory protection program. Remove any encapsulating protective garments.
Remove the respirator following the instructions for the SCOTT respirator you are using.
1. Turn OFF the RDI Voice Amplifier by pressing the ON/OFF button located
on the top of the facepiece assembly and holding for three (3) seconds.
2. Once the RDI Voice Amplifier is powered off, the Bluetooth
communications link between the RDI Voice Amplifier and two-way radio will
be disconnected. All radio transmit and receive communications functions will
be automatically routed to the two way radio or connected RSM (if installed).
Remove the RDI Voice Amplifier facepiece assembly as follows:
a) Loosen facepiece retention screw, if engaged.
b) Press the locking spring lever outward (away from facepiece).
c) With locking lever disengaged, rotate the facepiece assembly one
quarter turn clockwise (as viewed from the right hand exterior of the
facepiece) and lift the assembly away from the facepiece.
CLEANING AND INSPECTION
CLEANING
1. After use, the RDI Voice Amplifier may be cleaned with a damp sponge.
A solution of water and mild dish detergent may be used if necessary.
2. Take care prevent excessive amounts of water from entering the holes
for the speaker or the microphone. DO NOT IMMERSE THE FACEPIECE
ASSEMBLY IN LIQUID.
WARNING
DUE TO THE POTENTIAL FOR ELECTROSTATIC
DISCHARGE, CLEAN WITH DAMPENED CLOTH
ONLY. DO NOT USE DRY CLOTH TO CLEAN
THE SURFACE. ELECTROSTATIC DISCHARGE
MAY CAUSE A SPARK THAT COULD IGNITE A
FLAMMABLE OR EXPLOSIVE ATMOSPHERE
RESULTING IN SERIOUS INJURY OR DEATH.
REMOVING RDI VOICE AMPLIFIER ASSEMBLY
ROTATE CLOCKWISE TO OPEN OPENED POSITION
APX RADIO SIDE VIEWAPX RADIO SIDE VIEW
BT ON/OFF