Scott Safety Epic 3 - PROGRAMMING THE RDI VOICE AMPLIFIER; Programming Utilities and Modules

Page 8 of 21
P/N 595359-01 Rev A - 04/17
DRAFT COPY –
NOT FOR PUBLICATION
WARNING
THE EPIC 3 RDI VOICE AMPLIFIER
COMMUNICATIONS ASSEMBLY MUST BE
PROGRAMMED FOR THE TYPE OF BATTERIES
USED AS WELL AS FOR THE TYPE OF AUDIO
ACCESSORY BRACKET BEING USED. FAILURE
TO VERIFY THAT THE UNIT IS PROPERLY
PROGRAMMED MAY RESULT IN REDUCED
PERFORMANCE WHICH COULD LEAD TO
SERIOUS INJURY OR DEATH.
PROGRAMMING THE EPIC 3 RDI VOICE AMPLIFIER
The RDI Voice Amplier is designed for use with a SCOTT Full Facepiece equipped
with voicemitters and a compatible SCOTT audio accessory bracket. The audio
accessory brackets are available as either open or closed front depending on the
approved facepiece being used. For proper performance, the RDI Voice Amplier must
be programmed for the type of accessory bracket and batteries being used.
Each RDI Voice Amplier is preprogrammed at the factory for use with Alkaline
batteries and either an open accessory bracket or closed accessory bracket
conguration. RDI Voice Ampliers programmed for open brackets will emit 5 tones
upon startup and RDI Voice Ampliers programmed for closed brackets will emit 6
tones.
Programming the RDI Voice Amplier can be easily performed using either the SCOTT
EPIC 3 Programming Utility for Windows® PCs or the EPIC 3 Programming Utility
for iPhone. The Windows utility is available for free download from the Scott Safety
website, under the document section of the EPIC 3 RDI product page. It is also
available for download from the Scott Safety Distributor Passport Portal. The iPhone
utility is available for download from the Apple App Store. Search “Scott Safety” to
nd the EPIC 3 Conguration utility on the Apple app store.
• Programmer Module: The RDI Voice Amplier can be programmed using the
EPIC Programmer Module (P/N 201243-01) with the EPIC 3 Programming Utility
(P/N 31002979) to select, save, and congure settings using Bluetooth wireless
technology.
• Configuration Tone Sequences: The RDI Voice Amplifier can be
programmed using the SCOTT Programming Utility for Windows software
(P/N 31002979) to play tone sequences that correspond to selected settings
and allow the user to easily congure the settings for optimal performance. The
Programmer Utility for Windows can also be downloaded directly from the website
at http://www.scottsafety.com/EPIC3RDI
• The Scott Safety Distributor Passport Portal is available via the following link:
https://lsp.portal.relayware.com/?value=PARTNER%20PORTAL
RDI VOICE AMPLIFIER
ASSEMBLY P/N
201276-01 PRE-
PROGRAMMED
FOR AN OPEN
BRACKET
RDI VOICE AMPLIFIER
ASSEMBLY P/N
201276-02 PRE-
PROGRAMMED
FOR A CLOSED
BRACKET