Scott Safety Epic 3 - GENERAL DESCRIPTION; Product Overview and Key Warnings

Page 5 of 21
P/N 595359-01 Rev A - 04/17
GENERAL DESCRIPTION
The EPIC 3 Radio Direct Interface Voice Amplier (RDI Voice Amplier) provides
facepiece voice amplification and wireless radio voice communications when
Bluetooth® connected to a compatible portable two-way radio (supplied by the user).
The EPIC 3 RDI Voice Amplier is intended for installation only on approved SCOTT
respirators equipped with SCOTT full facepieces with dual voicemitters. Training is
required before use. These assemblies are not intended for use under water or for
any purpose not specically authorized by the organized respiratory program that
applies to the specic user.
The RDI Voice Amplier device attaches to the voicemitter bracket mounted on ei-
ther side of an approved Scott Safety full facepiece. Accessory mounting brackets
are available for compatible SCOTT respirator facepieces not already equipped with
voicemitter brackets.
The RDI Voice Amplier requires three (3) approved AAA batteries (installed in the
RDI Voice Amplier from the factory).
QUESTIONS OR CONCERNS
If you have any questions or concerns regarding use of this equipment,
contact your authorized SCOTT distributor, or contact SCOTT at 1-800-247-7257
(or +1-704-291-8300 outside the continental United States).
WARNING
THE USE OF AN INTRINSICALLY SAFE DEVICE
IN AN ATMOSPHERE FOR WHICH IT IS NOT
LISTED OR THE USE OF A NON-INTRINSICALLY
SAFE DEVICE IN A FLAMMABLE OR EXPLOSIVE
ATMOSPHERE MAY LEAD TO FIRE OR
EXPLOSION RESULTING IN SERIOUS INJURY
OR DEATH.
WARNING
TRAINING IS REQUIRED BEFORE USE,
ESPECIALLY IN AN EMERGENCY SITUATION.
USE OF THIS EQUIPMENT WITHOUT PROPER
TRAINING COULD LEAD TO SERIOUS INJURY
OR DEATH.