ST2134 Operation and Installation Manual
14
Diagnostic
The initialization (Init) function is as well very helpful for diagnostic of the correct blind wiring. If during
Initialization (Init) the communication to a blind is not possible or faulty (e.g. no blind connected, wiring
problem, …) the corresponding Blind LED lights red after initialization (Init) procedure.
IMPORTANT
Take in consideration that the blinds once connected to ST2134 are not reacting on 2-pole controls
(e.g. ST2121 or mechanical switch of ST1811) any more until parameter 3-Wire-Only is changed back
to OFF value (with CTS for blinds software).
To Next Page
Loading...
Need help?
General