ST2134 Operation and Installation Manual
21
Delete ALL Control Groups from one blind
To remove ALL assigned control groups from a blind:
1) Select blind (1, 2, 3, 4 or ALL) with Blind select button
(cyan LED indicates selected blind / another touch selects next blind)
2) Press and hold Group delete button long (>3s)
(red / cyan flashing LED during button holding)
(confirmation tone indicates removal of ALL control groups from the selected blind)
Delete ALL Control Groups from ALL blinds (RESET)
Full RESET of the entire control group table
To reset all control group assignments in a ST2134 operate the above sequence with selecting ALL
blinds in step 1) (all 4 cyan blind LEDs are on).
IMPORTANT
It is recommended to operate this full reset of the assignment table whenever the assignment is
unclear during configuration or the assignment table is long/full and should be fully cleared.
To Next Page
Loading...
Need help?
General