29
If you select 'P-1' in setting mode, the Analyzer prints only one copy in printing mode. If you select 'P-2', the Analyzer automatically
prints two copies.
Print one copy function
Print two copies function
If you have the 02LA20G model, you can print via Bluetooth or by using a mini USB cable. If you do not have the Bluetooth model, you
will need a mini USB cable to be able to print.
CHAPTER 5. Data transfer
Please contact your local distributor for more information on downloading results.
You can download LMS Software at www.sdbiosensor.com.
CHAPTER 6. Bluetooth communication
Only the 02LA20G model can be used to transfer data from an analyzer through Bluetooth. The model number is indicated on the label
of the analyzer.
1. Data Trasfer
The data measured by the analyzer can be transferred to a PC via Bluetooth (02LA20G model only).
If you want the analyzer to be paired with a PC, the pairing step is necessary. And the STANDARD Lipid Management Software (LMS)
should be installed on the PC. To start the pairing step, follow the steps below;
Pairing
1) At the strip stand-by state for either a lipid or glucose, press the ON/OFF button for 2 seconds. Then, ‘bt’ icon will appear on the left side of the screen with
the setting icon which means pairing is ready. When you run the device for the rst time, press the setup button and execute BT ON in the BT setup step.
BL BL
To Next Page
Loading...
Need help?
General