101
Antifreeze
717 engines only: Temporarily install a
short piece of hose to engine water in-
let at cylinder head.
Insert a funnel into hose and pour an-
tifreeze mixed with water in engine un-
til the colored solution appears at the
cooling system bleed outlet.
947 Carburetor-Equipped Engines
At this point, remove the hose pincher
at tuned pipe bleed hose. If necessary,
continue to pour antifreeze mix until
the colored solution appears at the oth-
er cooling system bleed outlet (stern
eyelet).
Remove the remaining hose pinchers
in this order to allow proper flow of an-
tifreeze.
1. Engine cylinder drain hose.
2. Water outlet hose.
787 RFI and 947 Carburetor-Equipped
Engines
787 RFI engines only: Disconnect hose
just above T-fitting from as shown.
1. Hose connecting to inlet fitting of cylinder
head
2. Disconnect hose above T-fitting
Install a hose pincher just below T-fitting.
1. Hose pincher below T-fitting
Pour approximately 300 mL (10 oz) of
antifreeze in the water regulator valve
supply hose to allow antifreeze flow-
ing through the valve and into muffler
to protect it.
Reconnect hose to T-fitting and re-
move hose pincher (if applicable).
All Models except DI Models
Remove temporary hose (on 717 en-
gines) and reconnect engine water out-
let hose.
Remove remaining hose pinchers.
F07E0LY
F15E02Y
12
F15E03Y
1
smo2002-002a.book Page 101 Monday, July 30, 2001 2:18 PM
To Next Page
Loading...
Need help?
General