102
DI Models
Hose Pinchers Installation
Some hoses have to be plugged to
prevent draining, before filling cooling
system jackets with the antifreeze.
Install hose pinchers at the following
location:
RX DI MODELS
1. Water outlet hose
1. Crankcase cooling cover outlet hose
1. Engine cylinder drain hose
Hose Disconnection
Disconnect water INLET hose at engine
between T-fitting and cylinder head fit-
ting.
1. Disconnect this side of the T-fitting
Temporarily install a short piece of hose
to replace the one removed.
Antifreeze
Insert a funnel into the temporary hose
and pour antifreeze mix in engine until
the colored solution appears at cooling
system bleed outlet.
At this point, install a hose pincher on
bleed outlet hose.
F12E02Y
1
F12E0AY
1
F07E0JY
1
F12E0BY
1
F07E0LY
smo2002-002a.book Page 102 Monday, July 30, 2001 2:18 PM
To Next Page
Loading...
Need help?
General