To Next PageTo Next PageWhy doesn't my SEA Control Unit gate close automatically?
The gate may not close automatically because the pause time is set too long, or the operating logic doesn't include automatic closing. To resolve this, adjust the pause time using Trimmer Rv3. Additionally, check dip1 and Trimmer Rv3 to verify the set logic.
What to do if the SEA SWING 2 Control Unit motor doesn’t respond to the START impulse?
If the motor isn't responding, it could be due to a missing bridge on one of the N.C. contacts or a burnt fuse. Check the connections or bridges on contacts 2/6 on Cn1 and 2/7 on Cn1. Also, replace the burnt fuse on the board.
How to fix a SEA Control Unit gate that doesn’t reach the complete open/close position?
If the gate isn't fully opening or closing, it could be due to several reasons: * A programming error: Repeat the programming. * An obstacle: Remove any obstructions. * Inadequate fitting geometry: Check the fitting geometry according to the operator installation manual. * Manual adjusting mode: Rotate Trimmer Rv4 clockwise.
What to do if SEA SWING 2 gate doesn’t move while the motor is running?
If the gate isn't moving while the motor is running, it could be because: 1. The motor is in the released position: Re/lock the motor. 2. Trimmer Rv1 is at minimum: Rotate Trimmer Rv1 to the maximum (clockwise). 3. There is an obstacle: Remove the obstacle. If the encoder function is on, decrease its sensitivity.
What to do if SEA Control Unit gate opens but doesn’t close?
If the gate opens but doesn't close, the photocells connections 2/6 and 2/7 might not be closed. Check the LED or bridges.
General| Brand | SEA |
|---|---|
| Model | SWING 2 |
| Category | Control Unit |
| Language | English |
Gate operation with two impulses for open/stop/close.
Gate operation with single impulse for open/close.
Gate operation with safety reversal on opening.
Gate operation with safety reversal and second impulse to close.
Adjusts motor thrust force for safety.
Adjusts slowdown time or leaf delay based on mode.
Adjusts pause time between opening and closing cycles.
Adjusts encoder sensitivity or opening/closing times.
Initial torque adjustment and connection verification.
Motor closing, then opening, setting leaf delay.
Releasing motor, positioning leaves, relocking.
Addresses issues where the motor does not respond to start commands.
Addresses issues like unexpected movement or stopping during operation.
Addresses issues where the gate does not reach the full open or closed position.
Addresses issues where the gate does not close automatically after a pause.
