SEA SWING 2 User Manual

OPERATING LOGICS
- SEMI - AUTOMATIC LOGIC
- AUTOMATIC LOGIC
A start impulse opens the gate. A second impulse during the opening stops the movement, a successive
impulse restarts the movement in closing. When the gate is in opening position a start
impulse is required for closing it again.
A start impulse in closing phase reverses the movement.
Note: Rotate the trimmer Rv3 completely clockwise.
A start impulse opens the gate. A second start impulse while the gate is opening is not accepted.
An impulse during the pause is not accepted. An impulse in closing phase reverses the movement.
- SAFETY AUTOMATIC LOGIC
A start impulse opens the gate. A second impulse in opening phase reverses the movement.
A start impulse during the closing phase reverses the movement.
- SAFETY SEMI - AUTOMATIC LOGIC
A start impulse opens the gate. A second impulse in opening phase reverses the movement.
When the gate is in opening position another impulse is required in order to reclose the gate.
A start impulse during the closing phase reverses the movement.
NB: Ruotare il trimmer Rv3 tutto in senso orario
OFF
FUNCTIONING LOGICS SELECTION (DIP1 E Rv3)
DIP1 position + Trimmer Rv3 to select semi - automatic logic
Rv3
MAX
ON
OFF
DIP1 position to select the automatic logic
DIP1
DIP1 position to select the safety automatic logic
MAX
ON
DIP1 position + Trimmer Rv3 to select the safety semi - automatic logic
SWING 2
25
DIP
1 2 3 4 5 6 7 8
ON
DIP
Rv3
Rv3
+-
+
ONON
Rv3
MAX
11 11 11
+
Rv3
MAX
11
PROGRAMMING LOGICS: SUMMING UP TABLE
OPERATING LOGICS (DIP-SWITCH)
English
Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
®
REV 07 - 05/2009

SEA SWING 2 Specifications

General

Brand	SEA
Model	SWING 2
Category	Control Unit
Language	English