10
Safety Stop
The user can set both the depth and the duration of the Safety Stop.
NOTES:
a) The Safety Stop is calculated and proposed if the maximum depth reached is
greater than 12 meters/40 ft.
b) The Safety Stop is shown when the diver comes within 9 meters/30 ft of the
surface.
c) The countdown begins if the diver arrives within +2 meters/+6.5 ft and
-2 meters/-6.5 ft of the stop depth set. For example: If the stop set is 5
meters/16.5 ft, the countdown starts between 7 meters/32 ft and 3 meters/10
ft. In this case then, if you go to a depth of less than 3 meters/10 ft., the stop
will be canceled.
d) The Safety Stop is not calculated and is not proposed if at least one deco stop
is underway within 9 meters/30 ft from the surface.
e) If the current dive includes one or more decompression stops, and if these
decompression stops are cleared during the ascent (before reaching 9
meters/30 ft) because of a very slow ascent or in any case a multilevel dive,
then the Safety Stop is calculated and proposed at the time and duration set
by the user.
f) If the Diver again exceeds a depth of 9 meters/30 ft after having performed
the stop, the Safety Stop is recalculated and reproposed in accordance with
the rules described above.
g) If the Diver descends to a depth greater than 9 meters/30 ft during the
countdown, it will be reset and recalculated according to the rules above.
To Next Page
Loading...
