8
TECHNICAL CHARACTERISTICS
Dive modes
The computer manages three dive modes:
I. Scuba mode:
Dive: When depth exceeds 150 cm/5 ft.
Emerge:when depth is less than 90 cm/3 ft.
II. Gauge mode:
Dive: when depth exceeds 150 cm/5 ft.
Emerge: when depth is less than 90 cm/3 ft.
III. Free Mode:
Dive: when depth exceeds 100 cm/3.3 ft.
Emerge:when depth is less than 50 cm/1.6 ft.
After a dive in SCUBA / GAUGE mode, the Computer stays on the SCUBA /
GAUGE screen for 10 minutes after emerging, and therefore you cannot access
the menu and submenu.
After a dive in FREE mode, the Computer stays on the FREE screen for 15 minutes
after emerging, and therefore you cannot access the menu and submenu.
After a dive in SCUBA or GAUGE mode, FREE mode is inhibited and is not
accessible for the next 12 hours.
After a dive in GAUGE mode, because tissue saturation is calculated assuming
that the dive uses mix number 1, SCUBA mode is available.
After a dive in GAUGE mode, the Desaturation and NoFly times are updated with
the new tissue saturation data. In particular, the NoFly time is set to 24 hours,
as a precaution in favor of safety, regardless of the type of profile that was run.
After a dive in FREE mode, the residual Desaturation and NoFly time, if any
existed before the dive in FREE mode, will be left unchanged.
To Next Page
Loading...
