22
Dive parameters (DIVESET)
When you have entered the “MODE” submenu, use the HR (+) or LR (-) buttons
to select the type of dive: using an open-circuit respirator (OC) "SCBA", or
in Instrument/Gauge mode (depth gauge/timer only) "GAGE", or again for
"FREE" dives. Confirm your choice of dive type with the LL button (Mode). The
appropriate icon (OC, GAUGE, or FREE) will turn on at the top of the screen
during the dive to display your choice. The “SFT LEV” screen will appear with a
flashing number. On this screen you can select the desired level of safety, from
0 to 5. In other words, you can choose whether you prefer your Action to be
more or less conservative when calculating the safety or decompression curve.
Selecting 5 means that you want to be as conservative as possible, while 0 is
the minimum value.
Once you have selected the value you want, press the LL button once to switch
to the S.S.TIME screen, where you can set the Safety Stop time in minutes,
meaning the safety stop to take before emerging. Values can be set with the HR
and LR buttons from 0 (no Safety Stop) to 5 minutes.
Pressing the LL button will switch you to the page for selecting the Safety Stop
depth: S.S.DPT. This can be set from 3 to 6 meters in depth using the HR and
LR buttons.
Press the LL button once. The DEEP STP screen will appear, where you can
select ON-OFF to decide whether or not to activate the Deep Stop. If you select
ON, Action will calculate the depth and time automatically. Confirm your choice
by pressing the LL button once.
The WATER screen will appear, in which you can select the water type, either
sea (SLT) or fresh (FRH). Confirm your choice with the LL button, or press the LL
and LR buttons at the same time to return to the main screen.
To Next Page
Loading...
