ACTION
5
• WARNING!
Always check that the settings are correct for your dive, and don't allow
anyone else to tamper with your computer before the dive. If it has been
tampered with by another person, check that your settings are correct.
• WARNING!
It is important to keep in mind that your body undergoes changes, even
daily changes, that a computer cannot account for. If your physical
condition is not excellent, or if you feel any physical problems, do not dive!
• WARNING!
The normal functions of the product could be disturbed by strong
electromagnetic interference.
In this case, simply reboot the product to restore normal function,
following the instructions provided in this manual (see “Reset”) and use
the product in another position.
• WARNING!
Strictly avoid pressing on the side grill of the sensor with your fingers,
especially if the sensor compartment is full of water, because this could
distort the measurement of zero, and could therefore result in an incorrect
measurement of depth during the next dive, with the consequence that
the NDL/Deco data may also be inaccurate.
In DIVE mode, if you notice a measurement of anything other than zero
on the surface, you need to reset the device to zero out the sensor
measurement (see the instructions and warnings on using the RESET
further on in this manual) or wait a few hours for the system to reestablish
the correct zeroing.
To Next Page
Loading...
