Seaga INF4C - Page 29

29Revision 2.EL950 1.3.1074C 18.6
ADVANCED*
A password is required to enter this menu. The factory default password is 2314. The following sub-menus
are available under this sub-menu:
• Beep Enable • Temp
• Optics Disables • Selection Style
• Motor Type
BEEP ENABLE
OPTICS DISABLES
MOTOR TYPE
STEP DISPLAY
1 Press Service Mode Buon Motor Count or Error Code **
2 Press 4 for Conguraon Conguraon
3 Press 0 for Advanced Cong Password: Use keypad to enter password
4 Press 1 for Beep Enable menu Beep Enable (Current Seng) *-Exit, no change 1-Edit
5 Press 1 to toggle ON/OFF Beep Enable (Choice Flashing) *-Exit, no change # to Save
6 Press # to save the seng Beep Enable (New Seng) *-Exit, no change 1-Edit
7 Press * three mes to exit 0.00
STEP DISPLAY
1. Press Service Mode Buon Motor Count or Error Code **
2. Press 4 for Conguraon Conguraon
3. Press 0 for Advanced Cong Password: Use keypad to enter password
4. Press 2 for Opcs Disables menu Opcs Disables (Current Seng) *-Exit, no change 2-Edit
5. Press 2 to toggle ON/OFF Opcs Disables (Choice Flashing) *-Exit, no change # to Save
6. Press # to save the seng Opcs Disables (New Seng) *-Exit, no change 2-Edit
7. Press * three mes to exit 0.00
STEP DISPLAY
1. Press Service Mode Buon Motor Count or Error Code **
2. Press 4 for Conguraon Conguraon
3. Press 0 for Advanced Cong Password: Use keypad to enter password
4. Press 3 for Motor Type menu Motor Type (Current Seng) *-Exit, no change 3-Edit
5. Press 3 to toggle 3-Wire or 2-Wire Motor Type (Choice Flashing) *-Exit, no change # to Save
6. Press # to save the seng Motor Type (New Seng) *-Exit, no change 3-Edit
7. Press * three mes to exit 0.00