Seaga INF4C - Page 35

35Revision 2.EL950 1.3.1074C 18.6
OPTICS BY ROW
OPTICS BY SELECTION

Turns ON or OFF the default scrolling display message.
STEP DISPLAY
1. Press Service Mode Buon Motor Count or Error Code **
2. Press 5 for Opons Menu Opons
3. Press 6 for Opcal Vend Menu Opcal Vend
4. Press 2 for to enter a Row Row: -- *-Exit
5. Enter the Row Row: X (Current Seng) *-Exit 1-Edit
6. Press 1 to toggle between ON and OFF Row: X (Choice Flashing) *-Exit #-Save
7. Press # to save the seng Row: X (New Seng) *-Exit 1-Edit
8. Repeat Steps 4 through 7 unl all desired rows are completed.
7. Press * to enter another Row or four mes to exit 0.00
STEP DISPLAY
1. Press Service Mode Buon Motor Count or Error Code **
2. Press 5 for Opons Menu Opons
3. Press 6 for Opcal Vend Menu Opcal Vend
4. Press 1 for to enter the Selecon Item: -- *-Exit
5. Enter the Item Number Item: XXX (Current Seng) *-Exit / 1-Edit
6. Press 1 to toggle between ON and OFF Item: XXX (Choice Flashing) *-Exit #-Save
7. Press # to save the seng Item: XXX (New Seng) *-Exit 1-Edit
8. Repeat Steps 4 through 7 unl all desired rows are completed.
7. Press * to enter another Selecon or four mes to exit 0.00
STEPS DISPLAY
1. Press Service Mode Buon Motor Count or Error Code **
2. Press 5 for Opons Menu Opons
3. Press 7 for POS Menu POS Message (Current Seng) *-Exit 7-Edit
4. Press 7 to toggle between ON and OFF POS Message (Choice Flashing) *-Exit #-Save
5. Press # to save the seng POS Message (New Seng) *-Exit 7-Edit
6. Press * three mes to exit 0.00