Seaga Quick Break Combo QB218 - Motor Type Settings; Temperature Settings

43QB218 6.1.2019 vers 1.0
4. Press 2 for Opcs Disables menu
Opcs Disables (Current Seng)
*-Exit, no change 2-Edit
5. Press 2 to toggle ON/OFF
Opcs Disables (Choice Flashing)
*-Exit, no change # to Save
6. Press # to save the seng
Opcs Disables (New Seng)
*-Exit, no change 2-Edit
7. Press * three mes to exit 0.00
MOTOR TYPE
Note: Must be set to 3 Wire.
STEP DISPLAY
1. Press Service Mode Buon Motor Count or Error Code **
2. Press 4 for Conguraon Conguraon
3. Press 0 for Advanced Cong
Password:
Use keypad to enter password
4. Press 3 for Motor Type menu
Motor Type (Current Seng)
*-Exit, no change 3-Edit
5.
Press 3 to toggle 3-Wire or 2-Wire
*Note: must be set to 3 wire
Motor Type (Choice Flashing)
*-Exit, no change # to Save
6. Press # to save the seng
Motor Type (New Seng)
*-Exit, no change 3-Edit
7. Press * three mes to exit 0.00
TEMP
Note: Must be set to COLD.
STEP DISPLAY
1. Press Service Mode Buon Motor Count or Error Code **
2. Press 4 for Conguraon Conguraon
3. Press 0 for Advanced Cong
Password:
Use keypad to enter password
4. Press 4 for Temp menu
Temp (Current Seng)
*-Exit, no change 4-Edit
5.
Press 4 to toggle Snack, Cold, Cold Food,
Slackened, Eng Test, Dual Zone, Dual Upper
-6, Chilled, MZF, MZF -2, MZF -5, SZ Frozen,
SZ Frozen -2, SZ Frozen -5, SZ Cold, SZ Cold -1
Temp (Choice Flashing)
6. Press # to save the seng
Temp (New Seng)
*-Exit, no change 4-Edit
7. Press * three mes to exit 0.00