Seaga Quick Break Combo QB218 - Front Door Operations; Location Requirements; Tool Kit; Installing the QB218

7QB218 6.1.2019 vers 1.0
Front Door
Unlocking – Insert the key into the lock and turn the key clockwise unl the T-Handle pops out – then turn the
T-Handle counter-clockwise 3 or more revoluons unl the door can be pulled open.
Locking – Close the door rmly. Turn the lock housing one revoluon clockwise and pull to test that the lock
spear has engaged with the locking mechanism. If the door does not open, push the lock housing into its
seated posion in the door.
Locaon Requirements
The IQ380 is meant for operaon indoors only – which not only means physical protecon from the elements
of sun, rain, etc. but also means a climate controlled environment. Locaon of the IQ380 in excessively hot,
cold, humid or dirty locaons will VOID YOUR WARRANTY.
Tool Kit
Suggested tools for your tool kit are:
Phillips screwdrivers
Adjustable pliers
Needle Nose pliers
Socket Set including 5.5 mm, 7 mm and 10 mm
Installing the QB218
1. Remove all shipment/packing materials, inspect unit for damage.
2. Place the Entrée Unit on the right side of the main unit and open the front door. Align the mounng holes
on the inside of the unit with the holes in the main unit. Using the bolts and washers provided, (2 each)
aach the Entree Unit to the main unit (Fig. 3).
Leg Levelers
Leg Levelers have been provided in your parts pack as it is essenal for proper operaon to have a level
vending machine. Installaon requires two people; one to slightly lt the machine while the other installs the
leveler by screwing it in to the base of the machine on all four corners.
Note: Care should be taken not to p the vending machine more than a few degrees. Excessive pping of the
machine can ruin your refrigeraon system and void your warranty.