Seagate Exos 7E10 - Drive specifications; Formatted capacity

Seagate Exos 7E10 Serial ATA Product Manual, Rev. B 7
2.0 Drive specifications
Unless otherwise noted, all specifications are measured under ambient conditions, at 25°C, and nominal power. For convenience, the
phrases the drive and this drive are used throughout this manual to indicate the Exos 7E10 Serial ATA drive models.
2.1 Specification summary tables
The specifications listed in the following tables are for quick reference. For details on specification measurement or definition, see
the appropriate section of this manual.
Table 1 Drive specifications summary
Drive specification
ST10000NM002B
ST10000NM006B
ST10000NM014B
ST10000NM017B
ST10000NM019B
ST10000NM021B
ST10000NM023B
ST10000NM025B
ST8000NM002B
ST8000NM006B
ST8000NM014B
ST8000NM017B
ST8000NM019B
ST8000NM021B
ST8000NM023B
ST8000NM025B
ST6000NM004B
ST6000NM008B
ST6000NM016B
ST6000NM019B
ST6000NM021B
ST6000NM023B
ST6000NM025B
ST6000NM027B
ST4000NM004B
ST4000NM010B
ST4000NM022B
ST4000NM024B
ST4000NM028B
ST4000NM030B
ST2000NM004B
ST2000NM010B
ST2000NM014B
ST2000NM017B
ST2000NM019B
Formatted (512 bytes/sector)
#
10TB 8TB 6TB 4TB 2TB
Guaranteed sectors
(see Section 2.2)
Heads
10 8 6 4 3
Discs
5 4 3 2
Bytes per logical sector
512
Bytes per physical sector
4096
Recording density, KBPI (Kb/in max)
2499
Track density,
KTPI (ktracks/in, 0 skew)
487
Areal density,
(Gb/in
2
, @ 0 skew mid-disk)
1215
Spindle speed (RPM)
7200
Internal data transfer rate
(Mb/s max)
2169
Sustained data transfer rate OD
(MiB/s max)
251 (263MB/s) 243 (255 MB/s) 229 (250 MB/s) 216 (226 MB/s)
I/O data-transfer rate
(MB/s max)
600
ATA data-transfer modes supported
PIO modes 0–4
Multiword DMA modes 0–2
Ultra DMA modes 0–6
Cache buffer
256MB (262,144KB)
Weight: (maximum)
720g (1.59 lb) 716g (1.58 lb) 650g (1.43 lb) 620g (1.37 lb)
Average latency
4.16ms
Power-on to ready (sec) (typ/max)
**
23/30
Standby to ready (sec) (typ/max)
23/30
Startup current (typical) 12V (peak)
2.5A
Voltage tolerance (including noise)
5V ±5%
12V ±10%
Operating drive temperature
*
5° to 60°C (Drive Reported Temperature)
Non-Operating temperature –40° to 70°C (Ambient Temperature, see sections 2.6.1 and 2.10)
Temperature gradient
(°C per hour max)
20°C (operating)
20°C (nonoperating)
Relative humidity
*
5% to 95% (operating)
5% to 95% (nonoperating)