Seagate Exos 7E10 - Page 9

Seagate Exos 7E10 Serial ATA Product Manual, Rev. B 8
#
One GB equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting.
* See Section 2.10, "Reliability" for rated MTBF device operating condition requirements.
** See Section 2.4, "Start/stop times" for additional information.
Relative humidity gradient 20% per hour max
Altitude, operating
–304.8 m to 3,048 m
(–1000 ft to 10,000+ ft)
Altitude, nonoperating
(below mean sea level, max)
–304.8 m to 12,192 m
(–1000 ft to 40,000+ ft)
Operational Shock
(max at 2 ms - typical)
Read 70 Gs / Write 40 Gs
Non-Operational Shock
(max at 2 ms - typical)
300 Gs
Linear Random Operating Vibration 5–500 Hz: 0.70 Grms
Random Rotary Operating Vibration 20–1500Hz: 12.5 rads/s²
Linear Random Non-Operating Vibration
2–500 Hz: 2.27 Grms ref
Drive acoustics, sound power (bels)
Idle
2.8 (typical)
3.0 (max)
During periods of drive idle, some offline activity may occur according to the
SMART specification, which may increase acoustic and power to operational levels.
Performance seek
3.2 (typical)
3.4 (max)
Nonrecoverable read errors 1 sector per 10
15
bits read
Annualized Failure Rate (AFR)
*
0.44% based on 8760 POH
Maximum Rated Workload
*
Maximum rate of <550TB/year
Workloads exceeding the annualized rate may degrade the drive MTBF and impact product reliability.
The Annualized Workload Rate is in units of TB per year, or TB per 8760 power on hours. Workload Rate
= TB transferred * (8760 / recorded power on hours).
Warranty
To determine the warranty for a specific drive, use a web browser to access the following web page:
www.seagate.com/support/warranty-and-replacements/.
From this page, click on the “Is my Drive under Warranty” link. The following are required to be pro-
vided: the drive serial number, model number (or part number) and country of purchase.The system
will display the warranty information for the drive.
Load-unload cycles
(command controlled)
600,000
Supports Hotplug operation per
Serial ATA Revision 3.3 specification
Yes
Drive specification
ST10000NM002B
ST10000NM006B
ST10000NM014B
ST10000NM017B
ST10000NM019B
ST10000NM021B
ST10000NM023B
ST10000NM025B
ST8000NM002B
ST8000NM006B
ST8000NM014B
ST8000NM017B
ST8000NM019B
ST8000NM021B
ST8000NM023B
ST8000NM025B
ST6000NM004B
ST6000NM008B
ST6000NM016B
ST6000NM019B
ST6000NM021B
ST6000NM023B
ST6000NM025B
ST6000NM027B
ST4000NM004B
ST4000NM010B
ST4000NM022B
ST4000NM024B
ST4000NM028B
ST4000NM030B
ST2000NM004B
ST2000NM010B
ST2000NM014B
ST2000NM017B
ST2000NM019B