Seagull Models Extra 260 - Mounting the Tail Wheel

EXTRA 260. Instruction Manual.
20
2
1
33mm.
MOUNTING THE TAIL WHEEL.
! 2) Set the tail wheel assembly in place.
The pivot point of the tail wheel wire should
be even with the rudder hinge line and the tail
wheel bracket should be on the plywood
plate.
! 3) Using a pen, mark the locations of the
four mounting screws. Remove the tail wheel
bracket and tiller and drill 1mm pilot holes at
the locations marked.
3x25mm.
! 1) You have to trim each axles and using a
tool cutting and cut-off wheel.
Caution when cutting the axles wear
protective goggles.
3x10mm.
Aluminium strap.
1
2
1
2
1
1
(1+2) Plastic clip.