Seagull Models PC-9 - Tail Assembly and Control Linkages; Installing the Horizontal Stabilizer

www.seagullmodels.com
15
Remove the covering.
INSTALLING THE HORIZONTAL STABILIZER.
Remove the covering.
 3) Peel off the backing from the self adhe-
sive covering strip. Apply the strip to the centre
section of the wing starting from the bottom
trailing edge. Wrap the strip all the way around
the wing until it meets the trailing edge again.
Trim off any excess strip.
Epoxy.
Epoxy.
WING TIP INSTALLATION.
Masking tape.