ZERO. Instruction Manual.
20
Repeat the procedure for the other aileron servo.
Wing.
Aileron.
M2 lock nut.
Snap keeper.
Servo arm.
3) Connect the linkage as shown and secure
the control wire with a snap keeper.
8mm
Snap keeper.
M2 lock nut.
Metal clevis.
1) Mark the control wire where it crosses the
servo arm hole.
Bend a t t he m ark.
2) Make a 90-degree bend at the mark and cut
off the excess wire leaving 8mm past the bend.
Cut.
8mm.
AILERON PUSHROD HORN INSTALLATION
Mark.
Pen.
To Next Page
Loading...
