SEAL 54Base - Material Specifications; Machine Specifications

12 User Manual 54Base
3.3 Material specifications
Maximum width: Metric American
Process up to 40°C (104 °F) 1400 mm 55.1 in.
Maximum roll diameter:
Material unwind (upper unwind) 240 mm 9.4 in.
Material unwind (bottom unwind) 305 mm 1 ft.
Release liner wind-up 160 mm 6.3 in.
Maximum panel thickness: 50 mm 2.0 in.
Roll core inside diameter: 76.2 mm 3.0 in.
3.4 Machine specifications
Power supply requirements:
Europe 1N/PE 230VAC +/- 10%, 50/60Hz, 8.5A
USA 1N/PE 115VAC +/- 10%, 50/60Hz, 15.0A
(NEMA 5-20 plug supplied)
For the correct supply voltage version refer to the identification label on the machine.
Standard number of shaft positions:
Material unwind 2 (auto-grip)
Release liner wind-up 1
Optional features:
Nip setting: 0–52 mm 0 – 2.05 in.
Pressure: 0.3–1.0 N/mm 1.71 – 5.71 lbf/in.
Process speed:
Maximum 5 m/min 16.4 ft/min
Slow mode 0.6 m/min 2.0 ft/min
Maximum roller temperature: 40 °C 104 °F
Noise level <70 dB(A)