Operating 23
English
5.4.2 Using the upper section only
Figure 14: Webbing upper section.
1.
Remove the image guide.
2.
Unwind the film from the upper or top unwind roll.
• Feed a film without release liner over the splitter bar (A).
• Feed a film with release liner underneath the splitter bar (B).
3.
Pull the film forward until approximately 10 cm (4 in.) is on the in-feed table.
If the film has a release liner:
• Peel off the release liner.
• Pull the release liner up and stick it to the tube on the wind-up position.
4.
Stick the leader panel to the film and feed the panel into the nip using slow mode.
Note:
Use a carrier board when processing thin images.
5.4.3 Upper and lower section
Figure 15: Upper and lower section webbed.
The film in the upper section is webbed first
1.
Feed the film underneath (B) the splitter bar (between splitter bar and upper roller)
• Film without a release liner must be fed over the splitter bar (A).
To Next Page
Loading...
