SEAL 62Base - Process Control Sheet

Process Control Sheet 23
English
7 Process Control Sheet
Note: We recommend that you make a photocopy of this page. With each successfully run application,
record the process and settings and a diagram of the webbing procedure. Keep the record so the
application can be repeated at a later date.
Hint: If a standard image is made available for each new process then sales materials and samples can be
developed for reference.
LAMINATOR SETTINGS
Media: __________________________________
________________________________________
________________________________________
Process: _________________________________
Application Use: ___________________________
Upper Unwind Shaft: _______________________
Lower Unwind Shaft: _______________________
Wind-up Shaft: ____________________________
Front Control Panel Settings
Main Roller Pressure: _______________________
Motor Speed Setting: ______________________
Heat Assist: [On/Off] ______________________
WEBBING SETTINGS
Web Tension Upper Unwind Shaft:
Light / Med. / Heavy ________________________
Web Tension Lower Unwind Shaft:
Light / Med. / Heavy ________________________
Images: Sheet Fed / Roll Easel ________________
Top Splitter: [Over/Under] __________________
Bottom Splitter: [Over/Under] _______________
Figure 24: Blank Webbing Diagram