Sealey MS087 - User Manual

To Next Page

MOTORCYCLE CO2 EMERGENCY TYRE

INFLATOR KIT

MODEL NO: MS087

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,

and properly maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE

THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR

PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

1. SAFETY

 WARNING! Take extreme caution when using this appliance, compressed air can cause serious injury.

9 Keep out of reach of children. This product is not for sale to under 18’s.

9 Cartridges freeze on discharge, use the supplied insulation sleeve.

9 Maintain the adaptor in good and clean condition for best and safest performance.

9 When not in use, clean and return to the wallet complete.

9 Wear eye protection.

9 Use cartridges with supplied adaptor only.

8 DO NOT discharge near face or body.

8 DO NOT use this appliance for any purpose other than that for which it has been designed.

8 DO NOT pierce the compressed air cartridges, other than in the supplied adaptor fully fitted to the tyre valve.

8 DO NOT unscrew from the adaptor until the cartridge is fully discharged.

8 DO NOT use the adaptor if damaged.

8 DO NOT expose the charged cartridges to direct sunlight or temperatures above 49°C (120°F). Danger of explosion.

8 DO NOT dispose of charged cartridge.

8 DO NOT take charged cartridges on board an aeroplane.

 WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations that

may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into

this product, but must be applied by the operator.

2. INTRODUCTION

CO2 tyre inator kit including adaptor for Schrader type valves (used by most cars and motorcycles and some bicycles). Includes 2 x 16g

canisters of CO2. Supplied in zipped storage pouch.

3. CONTENTS

Item Description Qty

1 Adaptor 1

2 CO

2 Cartridge 2

3 Insulation Sleeve 1

4 Zipped Pouch (not shown) 1

4. OPERATION

4.1. Ensure the adaptor (1) valve is closed; fit the knurled nut to the “Schrader” valve of a tubed deflated tyre. Wind the knurled nut of the

adaptor fully until tight.

4.2. Place the insulation sleeve (3) over a charged cartridge (2) and screw the sleeved cartridge into the adaptor port.

4.3. Screw the sleeved cartridge into the adaptor port, full depth.

4.4. The cartridge will discharge the CO

2 into the tubed tyre, controlled by opening the adaptor valve anticlockwise.

4.5. With caution, unscrew the sleeved cartridge slowly to ensure the cartridge is fully discharged safely.

4.6. If required repeat 4.1.,4.2., 4.3. and 4.4.

Refer to

instruction

manual

Wear eye

protection

Original Language Version

Valve, turn fully

clockwise to close.

Knurled nut

MS087 | Issue:2 (H,F) 16/07/19

Need help?

Do you have a question about the Sealey MS087 and is the answer not in the manual?

Summary

Safety Precautions

General Safety Warnings

Extreme caution advised due to serious injury risk from compressed air. Keep out of reach of children.

Cartridge Handling

Use insulation sleeve for freezing cartridges. Do not discharge near face/body. Do not pierce cartridges outside adaptor.

Adaptor Usage and Care

Maintain adaptor clean and good condition. Use only with supplied adaptor. Do not unscrew until fully discharged.

Temperature and Disposal

Do not expose charged cartridges to direct sunlight or >49°C. Do not dispose of charged cartridges or take on aeroplanes.

Operation Instructions

Connecting the Adaptor

Ensure adaptor valve is closed, then fit knurled nut tightly onto the tyre valve.

Inserting the Cartridge

Place insulation sleeve over cartridge, then screw sleeved cartridge fully into the adaptor port.

Inflating the Tyre

Discharge CO2 by opening adaptor valve anticlockwise. Unscrew cartridge slowly with caution after discharge.

Summary

Safety Precautions

General Safety Warnings

Extreme caution advised due to serious injury risk from compressed air. Keep out of reach of children.

Cartridge Handling

Use insulation sleeve for freezing cartridges. Do not discharge near face/body. Do not pierce cartridges outside adaptor.

Adaptor Usage and Care

Maintain adaptor clean and good condition. Use only with supplied adaptor. Do not unscrew until fully discharged.

Temperature and Disposal

Do not expose charged cartridges to direct sunlight or >49°C. Do not dispose of charged cartridges or take on aeroplanes.

Operation Instructions

Connecting the Adaptor

Ensure adaptor valve is closed, then fit knurled nut tightly onto the tyre valve.

Inserting the Cartridge

Place insulation sleeve over cartridge, then screw sleeved cartridge fully into the adaptor port.

Inflating the Tyre

Discharge CO2 by opening adaptor valve anticlockwise. Unscrew cartridge slowly with caution after discharge.

The Sealey MS087 is a Motorcycle CO2 Emergency Tyre Inflator Kit designed for rapid tire inflation in emergency situations. This compact and portable kit is manufactured to a high standard, ensuring reliable performance when used according to the provided instructions and maintained properly. It is intended for use with Schrader type valves, commonly found on most cars, motorcycles, and some bicycles.

Function Description:

The primary function of the MS087 kit is to quickly inflate a deflated tire using compressed CO2 gas from disposable cartridges. It provides a fast and convenient solution for roadside tire emergencies, allowing users to reinflate a tire sufficiently to reach a service station or their destination. The kit includes an adaptor that connects to the tire valve and a CO2 cartridge, which, when pierced, releases gas into the tire. The flow of CO2 is controlled by a valve on the adaptor.

Important Technical Specifications:

Model Number: MS087
Contents:
- 1 x Adaptor
- 2 x 16g CO2 Cartridges
- 1 x Insulation Sleeve
- 1 x Zipped Pouch (for storage)
Valve Compatibility: Schrader type valves
CO2 Cartridge Size: 16g (standard size for many inflators)
Operating Temperature for Cartridges: Do not expose charged cartridges to direct sunlight or temperatures above 49°C (120°F) due to the danger of explosion.
Safety Features: Includes an insulation sleeve to protect hands from freezing cartridges during discharge.
Storage: Supplied in a zipped storage pouch for easy portability and protection.

Usage Features:

The MS087 is designed for straightforward and safe operation, even in emergency conditions.

Preparation: Ensure the adaptor's valve is closed.
Connection to Tire Valve: Fit the knurled nut of the adaptor to the Schrader valve of the deflated tire. Wind the knurled nut fully until it is tight, ensuring a secure seal.
Cartridge Insertion: Place the insulation sleeve over a charged CO2 cartridge. This sleeve is crucial as CO2 cartridges freeze upon discharge, and the sleeve protects the user's hands from cold burns. Screw the sleeved cartridge into the adaptor port, ensuring it is fully seated to pierce the cartridge and create a seal.
Inflation: Once the cartridge is securely in place, open the adaptor valve by turning it anticlockwise. This will release the CO2 from the cartridge into the tire.
Discharge and Removal: With caution, slowly unscrew the sleeved cartridge to ensure it is fully discharged safely before removal. If further inflation is required, the process can be repeated with a new cartridge.
Portability: The entire kit, including the adaptor, CO2 cartridges, and insulation sleeve, fits into a compact zipped storage pouch, making it easy to carry on a motorcycle, in a car, or in a backpack.

Safety Warnings and Cautions:

General Safety: Use extreme caution as compressed air can cause serious injury. Keep out of reach of children. Not for sale to individuals under 18.
Cartridge Handling: Cartridges freeze upon discharge; always use the supplied insulation sleeve. Do not expose charged cartridges to direct sunlight or temperatures above 49°C (120°F) to prevent explosion. Do not dispose of charged cartridges. Do not take charged cartridges on board an aeroplane.
Usage Restrictions: Do not discharge near face or body. Do not use for purposes other than its design. Do not pierce cartridges except when fully fitted to the tire valve via the adaptor. Do not unscrew from the adaptor until the cartridge is fully discharged. Do not use the adaptor if damaged.
Eye Protection: Always wear eye protection during use.
Common Sense: The manual emphasizes that common sense and caution are essential factors that must be applied by the operator, as not all possible conditions and situations can be covered in the instructions.

Maintenance Features:

Cleaning: Maintain the adaptor in good and clean condition for best and safest performance. After use, clean the adaptor and return it to the wallet complete.
Storage: Store the kit in its zipped pouch when not in use to protect components and keep them together.
Warranty: The product comes with a 12-month guarantee from the purchase date, requiring proof of purchase for any claim.
Environmental Protection: Unwanted materials, tools, accessories, and packaging should be sorted and taken to a recycling center. When the product becomes unserviceable, any fluids (if applicable) should be drained into approved containers and disposed of according to local regulations.

The Sealey MS087 is a practical and essential emergency tool for any vehicle owner, particularly motorcyclists, providing a quick and effective solution for unexpected tire deflation. Its robust design, clear operating instructions, and emphasis on safety make it a reliable choice for roadside emergencies.