Sealey TSTVRK - Introduction; Specifications; Operation Instructions; Removing Tyre Valve

4.2. FITTING REPLACEMENT TYRE VALVE (FIG.4)
4.2.1. Where necessary, remove any dirt and corrosion from the area around the valve hole in the wheel rim.
4.2.2.  Screwthereplacementtyrevalvetothepush/pulldriver(g.4).
4.2.3. Generously lubricate the tyre valve body and the inside of the cone with a suitable rubber lubricant.
8 DO NOT use mineral oil or grease as this will cause the tyre valve body to deteriorate.
4.2.4. Place the thin end of the cone into the valve hole in the wheel rim and alignthetyrevalve(g.5).
4.2.5. Usethepush/pulldrivertoforcethetyrevalveallthewaythroughtheconeuntilithasenteredthewheel(g.6).
4.2.6. Pullthetyrevalveupwardsuntilitseatsinthewheelrim(g.7).
4.2.7. Unscrew the push/pull driver from the tyre valve and remove the cone.
4.2.8.  Inatethetyreandcheckforleaksaroundthevalvebody.
g.4
g.5
g.6
g.7
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 sales@sealey.co.uk www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceableandrequiresdisposal,drainanyfluids(ifapplicable)intoapprovedcontainersanddisposeoftheproductandfluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
TSTVRKIssue2(HF)15/04/19
Original Language Version
© Jack Sealey Limited