MiniWarden Manual 530-487-5007 3
IMPORTANT WARNING AND SAFETY INSTRUCTIONS
1 READ AND FOLLOW ALL INSTRUCTIONS
2 SAVE THESE INSTRUCTIONS
3 WARNING – To reduce the risk of injury, do not permit children to
use this product
4 DANGER – Risk of injury
4.1 Replace damaged cord immediately.
4.2 Do not bury cord.
4.3 Connect to a grounded, grounding type receptacle only.
4.4 Do not use an extension cord.
5 WARNING – This product is provided with a ground-fault circuit-
interrupter at the end of the power cord. The GFCI must be tested
before each use. With the MiniWarden on and operating, push the
test button on the GFCI and the MiniWarden should turn o. Now
push the reset button on the GFCI and the MiniWarden should now
operate normally. When the product fails to operate in this manner,
there is a ground current owing indicating the possibility of an
electric shock. Disconnect the power until the fault has been
identied and corrected.
6 It is very important to follow the safety guidelines in this manual to
ensure safe installation and programming. Upon installation, it is
important to properly train all personnel basic water quality
management techniques, proper operation and programming to
anyone who operates or services MiniWarden.
7 All applicable local installation codes and ordinances must also be
adhered to. Improper installation will create an electrical hazard
which could result in death or serious injury to pool users, installers
or others due to electrical shock, and may also cause damage to
property. The MiniWarden must be installed by a licensed or certied
electrician or a qualied pool professional:
7.1 United States: National Electrical Code (NEC), NFPA 70
7.2 Canada: Canadian Electrical Code (CEC), CSA C22.1.
To Next Page
Loading...
Need help?
General