MiniWarden Manual 530-487-5007 18
PROGRAMMING - GETTING STARTED
The menu tree below represents the “Getting Started” menus that are necessary to get MiniWarden setup.
The remaining menus represent more advanced features that will be covered in later sections. Become very
familiar with the 4 menus below surrounding the Main Menu as they will be utilized most of the time. Any
menu utilizing the Back button for access can be password protected.
Step 1 - System Menu
The rst step is to set the Date, Time and Day of the Week in the System Menu. Press the Back button to
access the “Main Menu” and scroll down to the “System Menu” and set the correct Date, Time and Day of
the week and then proceed to Step 2 below. Much more will be covered on the “System Menu” in the
Advanced section of this manual.
Step 2 - Security Setup Menu
The next step is to set up and assign passwords to the various personnel who will be working with or
servicing MiniWarden. Menus that are accessed from the “Default Readings Screen” using the Back
button can be password protected. The Handy Menu, Flow Menu and Alarm Menu are not Password
Protected - anyone can access them. From the “Default Readings Screen”, simply press the Back button
to access the “Main Menu” and use the Down Arrow to scroll to “Security Setup”. There are 3 levels of
access that are dened below. Scroll to the level and assign up to a 10 digit password (numbers only) and
press “Enter” to save the password. Entering zero “0” will disable a password and the maximum value for
any password is 4294967295.
● 1 Admin Password: Access to all menus within MiniWarden including ability to add, delete, or
change passwords. If the Admin Password has been lost, please read the troubleshooting section
at the end of this manual.
● 2 Technician Passwords: Access only to the Service, Data Recording and Relay Setup menus.
● 7 Service Passwords: Access only to the Service and Data Recording Menus.
Service
Relay Manual
Calibration
Disable Relays
Clear Overfeed
ORP pH Tf Flow
681 7.7 75 ON a
OFF
Rly ↑↓
Default Readings Screen
Press
Back Key
GETTING STARTED
PROGRAMMING
Back
Relays
pH Acid(pH-)
ORP Liquid(ORP+)
Alarm Standard
Security
0Admin
1Tech
2Tech
3-9Service
Relay Type
PH Acid(pH-)
ORP Liquid(ORP+)
Alarm Standard
Name: Pool1
m
v
Service LAN
Data Security
Relays Relay Type
System TrueDPD
Main Menu
To Next Page
Loading...
Need help?
General