128 Lights and visibility
Note
● An overload cut-out may be triggered if the sun blind for the rear window
is operated repeatedly. There will then be a short delay before the blind can
be operated again.
● As the material of the sun blind is less flexible at low temperatures, the
electric actuator is switched off when the outside temperature is below
-5 °C. The sun blind can only be operated when the temperature inside the
car rises above this level.
Windscreen wipers
Windscreen wipers
The windscreen wiper lever controls the windscreen wipers
and the automatic wash and wipe.
Fig. 101 Windscreen
wiper lever
The windscreen wiper lever ⇒ fig. 101 has the following settings:
Short wipe
– Move the lever down to position
1
to give the windscreen a
short wipe.
Intermittent wipe / Rain sensor* (activate)
– Move the lever up to position
2
.
– Move the switch
A
up or down to set the wiper intervals.
– In vehicles equipped with a rain sensor*, you can move the
switch
A
up and down to set the sensitivity of the rain sensor.
Slow wipe
– Move the lever up to position
3
.
Continuous wipe
– Move the lever up to position
4
.
Automatic wash and wipe
– Pull the lever towards the steering wheel,
5
, to activate the
windscreen washer.
– Release the lever. The washer will stop and the wipers will keep
running for approximately 4 seconds.
Deactivating the windscreen wiper
– Pull the lever to basic position
0
.
General notes
The washers and wipers will work only when the ignition is switched on.
To Next Page
Loading...
