280 If and when
Sun visor light
Fig. 224 Removing sun
visor light
Fig. 225 Removing sun
visor light
– Remove the bulb carefully, using the flat part of a screwdriver
⇒ fig. 224.
– Use a screwdriver to remove the protective cover.
– Remove the bulb, moving it in the direction of the arrow and
outwards ⇒ fig. 225.
Jump-starting
Jump leads
The jump lead must have a sufficient wire cross section.
If the engine fails to start because of a discharged battery, the battery can
be connected to the battery of another vehicle to start the engine.
Jump leads
Jump leads must comply with standard DIN 72553 (see manufacturer's doc-
umentation). The wire cross section must be at least 25 mm
2
for petrol en-
gines and at least 35 mm
2
for diesel engines.
Note
● The vehicles must not touch each other, otherwise electricity could flow
as soon as the positive terminals are connected.
● The discharged battery must be properly connected to the vehicle elec-
trical system.
To Next Page
Loading...
