174 Driving
Setting the speed
The desired cruising speed has to be stored in the memory.
Fig. 140 Controls for the
cruise control system
– Drive at the desired speed.
– Pull the lever
A
to position ⇒ fig. 140
1
to activate the sys-
tem.
– Briefly press button
B
.
When button
B
is released, the current speed is stored in the memory and
the vehicle will then maintain this speed.
Adjusting the stored speed
The desired cruising speed can be adjusted up or down as
required.
Acceleration
– Move the lever
A
up towards ⇒ fig. 140
+
.
– Release the lever to store the current cruising speed.
Deceleration
– Move the lever
A
down towards ⇒ fig. 140
-
.
– Release the lever to store the current cruising speed.
Pressing lever
A
briefly
– You can increase the set speed in steps of 2 km/h by briefly
pressing the lever
A
up towards ⇒ fig. 140
+
.
– You can decrease the set speed in steps of 2 km/h by briefly
pressing the lever
A
down towards ⇒ fig. 140
-
.
You can also use the accelerator pedal momentarily to increase speed. The
previously programmed speed will be automatically resumed when the ac-
celerator pedal is released.
However, if the vehicle exceeds the programmed speed by more than 10
km/h for more than 5 minutes, the programmed speed will be deleted. You
will then need to enter the speed again.
To Next Page
Loading...
